Questions and Answers
• Why does the tool not rotate freely after assembly of a new CoolSpeed mini?
Most likely this is due to the tool shank touching the CoolSpeed mini rear cover. Disassemble the Tool Assembly from the
CoolSpeed mini, place it back into the Assembly Device, and press the tool further through the turbine and bearings. There
should be no more than 5 mm tool shank remaining from the rear bearing.
• Can I place the CoolSpeed mini into the machine magazine during machine set up?
Sure you can. As the CoolSpeed mini fits into standard sealed tool holders, you may place several CoolSpeed minis into the
machine magazine during machine set up.
• Can I store the CoolSpeed mini and re-use tomorrow?
Yes. Remove the CoolSpeed mini from the tool holder, wash through with running water, spray with WD-40, and place in a safe
place. Assure the tool is not damaged.
• Through coolant pressure seems to decrease. What should I do?
A decrease in through coolant pressure is most likely a result of the machine’s filters condition. It is recommended to clean
wash the filters at the start of each day. A decrease in through coolant pressure will severely affect the CoolSpeed minis
performance.
To Next Page
Loading...
