Wyrestorm EX-70-H2X - Page 3

Copyright © 2018 WyreStorm Technologies | wyrestorm.com
EX-70-H2X v2 Quickstart Guide | 181023
UK: +44 (0) 1793 230 343 | ROW: 844.280.WYRE (9973)
support@wyrestorm.com
3 of 4
Setup and Conguration
EDID Conguration
EDIDs can be congured to resolve issues with video output on displays that
may not accept the maximum resolution available from the source.
• Ensure that a display is connected and powered On tto the selected output
before copying EDIDs or the copy will fail. When this occurs, the EDID will be
set to 4K @30Hz 2ch.
• Power to the extender must be cycled (Off/On) after changing dip switches
in order for the setting to take effect
Note: Switches shown in gray can be in any position for the described function
EDID Copy (Default)
4K@30Hz/8bit only
2ch audio without
HDR
4K@60Hz 2ch audio
without HDR
4K@30Hz 2ch audio
with HDR
4K@60Hz 2ch audio
with HDR
4K@30Hz 7.1ch audio
with HDR
4K@60Hz 7.1ch audio
with HDR
1080P@60Hz 2ch
Long Cable Mode
This extender can be set to allow for extending 2K HDBaseT signals up to
140m/459ft by setting Long Cable Mode On. We recommend that this mode
is set to Off for cable runs of 100m/328ft or less. These settings apply to the
Setting dipswitch located on the transmitter.
Note: Switches shown in gray can be in any position for the described function.
Long Cable Mode On
1 2 3
ON
Long Cable Mode Off
1 2 3
ON
RS-232 Mode Settings
The RS-232 connector is used to transmit RS-232 over HDBaseT to the remote location and for rmware updates. Ensure that the RS-232 Mode switch on the
receiver and the Setting dipswitches on the transmitter are the proper position for the operation being performed.
Receiver RS-232 Mode Switch
Set the mode switch to Normal to transmit RS-232
signals from the TX to the RX for controlling devices
in the remote location.
Set the mode switch to the Update position to install
a rmware update in either the TX or RX.
Transmitter Setting Switch
RS-232 Pass-Through (DEFAULT)
1 2 3
ON
HDBaseT Update
1 2 3
ON
Note: Switches shown in gray can be in any position for the described function.
Troubleshooting
No or Poor Quality Picture (snow or noisy image)
• Verify that power is being supplied to the transmitter and receiving device.
• Verify that all HDMI and HDBaseT connections are not loose and are
functioning properly.
• Verify that the HDBaseT cable is properly terminated following EIA568B
standard.
• Verify that the output resolution of the source and display is supported by
this extender.
• Congure EDID Settings to a lower resolution. Refer to EDID Conguration
for details.
• If transmitting 3D or 4K, verify that the HDMI cables used are 3D or 4K rated.
No or Intermittent 3rd party Device Control
• •erify that the IR, RS-232, and Ethernet cables are properly terminated
following the Wiring and Connections section.
• Verify that RS-232 modes are properly selected for the desired operation.
Refer to RS-232 Mode Settings for details.
Troubleshooting Tips:
• WyreStorm recommends using a cable tester or connecting the cable to
other devices to verify functionality.