Copyright © 2015 WyreStorm Technologies | wyrestorm.com
Method 2 - Shared Port for Switcher and Remote Device Control
Use this method for switcher and remote device control when there is a single port available on the control system.
Use Method 1 - Individual Ports for Switcher and Device Control to control the switcher, local, and remote devices via multiple RS-232
ports on the control system.
Note:
This method can only be used if the switcher will not be controlling a local device using RS-232 2 as the port will be used to jump the
signal to the HDBaseT RS-232.
To Next Page
Loading...
