10
Using the Cigarette Plug Wire Assembly
Loads under 150 watts
When you are going to power loads
under 150 watts, use the cigarette plug wire assembly.
To connect the inverter:
1. Remove the nuts from the DC terminals on the inverter.
2. Place the red ring connector on the inverter’s red
(positive +) DC terminal, and then screw the red nut on
until it is snug. Do not over tighten.
3. Place the black ring connector on the inverter’s black
(negative –) DC terminal, and then screw the black nut
on until it is snug. Do not over tighten.
4. Place the lighter plug in the vehicle’s cigarette lighter
socket or a 12 volt outlet.
Caution!
Fire hazard.
The wires in most 12 volt sockets or power outlets
are not large enough for loads greater than 150
watts: they will overheat and present a fire hazard.
Do not use loads greater than 150 watts with the
cigarette plug wire assembly.
Caution!
Damage to the 300 Inverter.
Reversing the positive and negative battery cables
will damage the inverter and will void your
warranty.
Double check the wiring connections: the red
connector must be connected to the red terminal,
and the black connector must be connected to the
black terminal.
To Next Page
Loading...
