11
5. Turn on the inverter’s On/Standby switch. The
PWR
light
comes on, and AC power is available at the outlet.
Note: You may need to turn the vehicle’s ignition key
to the accessory position.
6. Plug in the AC load you want to operate.
Using the Battery Clip Wire Assembly
Loads greater than 150 watts
When you are going to power
loads that are greater than 150 watts (up to 300 watts
continuous power), connect the inverter to a 12 volt battery
using the battery clip wire assembly.
Warning!
Corrosive materials and energy
hazard.
To reduce the risk of irritation and burns, wear
protective eyewear and clothing when you work
with batteries.
Take special care to ensure that metal tools or
personal objects like rings or watches do not contact
the battery terminals.
To Next Page
Loading...
