10 Freedom X Owner’s Guide
Installation Tools and Materials
You will need the following to install the Freedom X:
❐ Wire stripper
❐ Mounting (#2) screws or bolts
❐ #2 Phillips screwdriver
❐ 3mm slot long neck screwdriver for spring clamp AC terminals
❐ Wrench for DC terminals (½" or 13mm socket wrench)
❐ AC cable (that is, two-conductor-plus-ground cable), sized
appropriately for load and application
❐ ½" Strain relief clamps (for the AC knockouts)
❐ Wire nuts or crimp connectors for AC wire and appropriate
tools
❐ DC cable, sized appropriately for load and application
❐ Lugs for DC cables to fit
5
/
16
" DC stud terminals as well as
appropriate tools (like a crimping tool)
❐ AC and DC disconnects and over-current protective devices
Freedom X Series INV Owners Guide.book Page 10 Tuesday, June 27, 2017 4:10 PM
To Next Page
Loading...
