18 Freedom X Owner’s Guide
Basic Installation Procedures
Step 3: Mounting the Unit
To mount the Freedom X:
1. Remove the Freedom X from its shipping container, verify that
all components are pres
ent, and record relevant product
information on “Information About Your System” in the
Owner’s Guide.
2. Select an appropriate mounting lo
cation and orientation. (See
Figure 2 below.) To meet regulatory requirements, for use in
on-land applications, the Freedom X must be mounted in one of
the fo
llowing orientations:
Figure 2 Approved Mounting Orientations
• Under a horizontal surface (see A)
• In a horizontal position on a vertical surface (see B)
• On a horizontal surface (see C)
3. Mark the desired number of mounting holes on the wall by
pl
acing the unit on the wall.
4. Pilot-drill the mounting holes.
5. Fasten the Freedom X to the mounting
surface. If you are
mounting the unit on a wall or bulkhead, use #12 or #14 pan-
head wood or sheet metal screws to secure it to the framing
behind the wall or bulkhead. Alternatively, use nut inserts and
¼"-20 machine screws.
NOTE: For marine installations, only this orientation is allowed, due to
the probability of moisture finding access into the enclosure.
Freedom X Series INV Owners Guide.book Page 18 Tuesday, June 27, 2017 4:10 PM
To Next Page
Loading...
