Xantrex 817-1000 - Inverter Operation

975-0787-01-01 25
Basic Installation Procedures
This section for use by qualified personnel only.
AC Output Connections
To make a permanent connection to existing AC wiring:
N
L
G
10mm
to circuit
breaker
AC Output knockout
NOTE: install a strain
relief clamp (not shown)
•
N
•
G
•
L
1. Ensure AC and DC power sources are turned off, if not already
done from “Step 4: Connecting the AC Input Wires” on page
20.
2. Install the required circuit breaker in the inverter distribution
panel
receiving AC power from the inverter.
3. Remove the AC compartment cover, if not already done from
“Step 4: Connecting the AC Input Wires” on page 20.
4. Strip a single AC output wire, as appropriate.
5. Remove the knockout and install a ½" strain relief clamp.
6. Route the wires through the strain relief clamp (not shown in
th
e figure).
7. Locate the Neutral, Ground and Line terminals on the AC OUT
termi
nal labeled as N, G, and L respectively.
8. Using a 3mm slot long neck screwdriver, open the spring clamp
by
inserting the tool in the clamp slot and gently pulling the
screwdriver handle forward, for Ground terminal.
9. Insert Line AC wire into Line (L) termin
al slot on the unit.
10. Release the spring clamp to secure the wire.
11. Repeat Step 8 through Step 10 for Ground (G) an
d Neutral (N)
connections.
12. Tighten the strain relief clamp
to secure the wires.
13. Replace the AC compartment cover
, if you are finished with
connecting all the AC wires in the unit.
14. Connect the other end of the wires to
a circuit breaker in the
inverter distribution panel.
Freedom X Series INV Owners Guide.book Page 25 Tuesday, June 27, 2017 4:10 PM