975-0787-01-01 35
This section for use by qualified personnel only.
Marine Installation
Figure 7 illustrates a typical marine installation with the following
components:
1. AC power supplied from a shore power connector
2. An AC source panel that includes a max 30A (or a 20A if using
a
GFCI) circuit breaker that supplies the Freedom X
3. An AC load panel with branch circuit breakers that supply only
loads
that run off the Freedom X
4. Engine negative bus / DC ground bus
5. DC power supplied by a battery bank and protected by a DC
fu
se in the positive cable
6. Battery isolator
7. DC alternator
8. Starting battery
9. Drip shield (see next page)
Figure 7 Typical Marine Installation
To Next Page
Loading...
