975-0787-01-01 37
Marine Installation
This section for use by qualified personnel only.
To install the drip shields:
1. Gather the four screws needed to fast
en a single drip shield to a
wall.
2. Locate an appropriate setting for the drip shields above the
Freedom
X making sure you cover the entire width of the unit.
You can overlay the shields as shown in Figure 9 below.
3. Fasten the screws through the holes in the drip shield into the
wall. See Figure 8.
Figure 9 Typical Drip Shield Placement on a Freedom X
1
000
Freedom X Series INV Owners Guide.book Page 37 Tuesday, June 27, 2017 4:10 PM
To Next Page
Loading...
