975-0753-01-01 3
This guide for use by qualified personnel only.
Installation Tools and Materials
You will need the following to install the Freedom Xi:
❐ Wire stripper
❐ Mounting screws or bolts
❐ #2 Phillips screwdriver
❐ 3.5mm slot long neck screwdriver for WAGO
1
terminals
❐ Wrench for DC terminals (1/2" or adjustable)
❐ AC cable (that is, two-conductor-plus-ground cable), sized
appropriately for load and application
❐ Wire nuts or crimp connectors for AC wire and appropriate
tools
❐ Two 1/2" strain-relief bushings (supplied) for AC cables
❐ DC cable, sized appropriately for load and application
❐ Lugs for DC cables to fit 5/16" DC stud terminals as well as
appropriate tools (like a crimping tool)
❐ AC and DC disconnects and over-current protective devices
1. WAGO® manufactures connection devices such as terminal blocks and related accessories.
Many Freedom Xi models use WAGO terminal blocks as AC input and output connections.
Freedom XI Install Guide.book Page 3 Friday, September 18, 2015 2:48 PM
To Next Page
Loading...
