4 Freedom Xi Installation Guide
High Level Overview of Installation Steps
Installing the Freedom Xi includes the following steps.
1. Ensure that power sources are OFF, like opening the DC
disconnect switch and opening circuit breakers on the AC
source panel.
2. Mount the inverter securely and permanently in one of the
acceptable orientations.
3. Connect the Equipment Grounding Terminal to the equipment
ground bus.
4. Connect the AC input wiring to the AC source panel.
5. Connect the AC output wiring to the AC load panel.
6. Connect one end of the DC negative cable to the negative
terminal of the battery and the other end to the negative
terminal of the unit.
7. Install an appropriately sized fuse and DC disconnect in the
positive cable.
8. Connect the DC positive cable to the positive terminal of the
battery and to the positive terminal of the unit.
9. Close the DC disconnect switch. Close the circuit breakers on
the AC source panel.
Do not proceed with installation until you have read “Safety
Instructions” on page 2.
Freedom XI Install Guide.book Page 4 Friday, September 18, 2015 2:48 PM
To Next Page
Loading...
