975-0753-01-01 19
Basic Installation Procedures
This guide for use by qualified personnel only.
AC Output Connections for the Standard Models
To make a permanent connection to existing AC wiring:
1. Ensure AC and DC power sources are turned off.
2. Install the required circuit breaker in the
inverter distribution panel
receiving AC power from the inverter.
3. Remove the AC compartment cover plate.
4. Strip a single strand (e.g. Romex) AC output wire, as
appropriate.
5. Locate the Line, Ground and Neutral terminals on the AC OUT
terminal labeled as L, G, and N respectively.
6. Using a 3.5mm slot long neck screwdriver, open the WAGO cage
clamp by
inserting the tool in the clamp slot and gently pulling the
screwdriver handle forward, for Ground terminal.
7. Insert Ground AC wire into Ground terminal slot on the unit.
8. Repeat steps 6 and 7 for Line and Neutral
connections.
9. Replace the AC compartment cover plate.
10. Connect the other end of the wires to a circuit breaker
in the inverter
distribution panel.
Freedom XI Install Guide.book Page 19 Friday, September 18, 2015 2:48 PM
To Next Page
Loading...
