975-0753-01-01 31
Marine Installation
This guide for use by qualified personnel only.
To install the drip shields:
1. Gather the four screws needed to fast
en a single drip shield to a
wall.
2. Locate an appropriate setting for the drip shields above the
Freedom
Xi making sure you cover the entire width of the unit.
You can overlay the shields as shown in Figure 11 below.
3. Fasten the screws through the holes in the drip shield into the
wall. See Figure 10.
Figure 11
Typical Drip Shield Placement on a Freedom Xi 2000
To Next Page
Loading...
