Installation
2–10 152602
GT100E MS Control Power Cable
To make GT100E MS Control Power Cable connections:
1. Connect the GT100E MS combiner box power cable assembly P/N 1-
152492-01 from the GT100E #1 through the access panel and connect
it to P1, see Figure 2-7.
2. Connect the GT100E MS combiner box power cable assembly P/N 1-
152492-01 from the GT100E #2 through the access panel and connect
it to P2, see Figure 2-7.
3. Connect the Cables ground wires to the ground terminal using a M5
nut.
4. Reinstall the safety cover into the GT100E MS Combiner box using 8
M6 screws.
Figure 2-7
GT100E MS Power Control Cable Connections
Combiner Box
Connector P1
Combiner Box
Connector P2
Combiner Box
Ground Terminal
GT100E MS Combiner
Box Power Cable
Assembly P/N 1-
To Next Page
Loading...
