iii
About This Manual
Purpose
The purpose of this Owner’s Manual is to provide explanations and
procedures for installing and configuring the GT100E MS Combiner Box
for Master/Slave Configuration.
Scope
The Manual provides safety guidelines, procedures for installing the
GT100E MS Combiner Box for Master/Slave Configuration, as well as
information about configuring the combiner box. It does not provide
details about the GT100E Grid Tie Inverter. You need to consult the
GT100E Grid Tie Inverter Installation Manual (P/N 152364) and GT100E
Grid Tie Inverter Operation, Maintenance and Troubleshooting Manual
(P/N 152365) for this information.
Audience
The Manual is intended for anyone who needs to install and operate the
GT100E MS Combiner Box for Master/Slave Configuration. Installers
should be certified technicians or electricians.
Organization
This Manual is organized into three chapters:
Chapter 1, “Introduction”, Chapter 1 contains a description of the
GT100E MS and lists the different operating states available with the
GT100E MS Combiner Box.
Chapter 2, “Installation”, Chapter 2 contains procedures on how to mount
the GT100E MS and make the cable connections.
Chapter 3, “Configuration”, Chapter 3 describes how to configure the
GT100E MS for Master/Slave configuration.
To Next Page
Loading...
