Xantrex GT3.0 - Figure 3-8 Male Network Terminator; Figure 3-9 Xanbus RJ45 Ports in the GT Inverter Wiring Box

Communications Wiring for Inverters in Parallel
975-0131-01-01 3–13
Terminators Male network terminators (Figure 3-8) are required at both ends of the network to
ensure the communication signal quality on the network.
GT Inverter Xanbus
Ports
Two RJ45 ports are provided in the GT Inverter, accessible from the wiring box.
See Figure 3-9 for the location of these ports.
Figure 3-8 Male Network Terminator
Figure 3-9 Xanbus RJ45 Ports in the GT Inverter Wiring Box
RJ11 ports
(not used)
RJ45
Xanbus ports
RS-232 port (used to connect a PC to use the GUI.
See “Custom Screens” on page 5–9)
Male network terminator