Installation
Inspection, Cleaning, and Packing
32 Operating Manual for XHR Series Power Supply
Inspection, Cleaning, and Packing
Initial
Inspection
When you first receive your unit, perform a quick physical check.
1. Ensure that each package contains the power supply and an AC input cord.
2. Inspect the unit for scratches and cracks, and for broken switches, connectors,
and displays.
3. If you suspect internal damage, have a service technician check the unit.
If the unit is damaged, save all packing materials and notify the carrier immediately.
See packing instructions in “Packaging for Shipping or Storage”.
Periodic
Cleaning
No routine servicing of the power supply is required except for periodic cleaning.
Whenever a unit is removed from operation, clean the metal surfaces with naphtha
or an equivalent solvent and the front panel with a weak solution of soap and water.
Use low pressure compressed air to blow dust from in and around components on the
printed circuit boards.
TM-XROP-01XN.book Page 32 Monday, March 22, 2004 4:10 PM
To Next Page
Loading...
