Remote Operation
Remote Analog Programming of Output Voltage and Current Limit
70 Operating Manual for XHR Series Power Supply
Figure 4.1 Connecting Programming Sources to J2 Connector
Sample
Configuration
The sample configuration in Figure 4.2 shows the required settings and connections
for:
• 0-10 Vdc programming of the output voltage
• local control (front panel control) of the output current limit
Figure 4.2 Sample Analog Programming Configuration
SW1-3: ON (CLOSED)
J2 Jumper: 3 to 4
TM-XROP-01XN.book Page 70 Monday, March 22, 2004 4:10 PM
To Next Page
Loading...
