Installation
2–6 975-0298-01-01
Ordering Network Components
Table 2-1 provides a partial list of network components and part numbers.
Ready-made cables are available in standard lengths from 3 feet to 75
feet.
For the most up-to-date list, call your dealer. Call your dealer or visit the
Outlet Store at www.xantrex.com to purchase cables and other network
components.
Network Layout
Xanbus-enabled devices can be connected in one of two Xanbus System
layouts: multi-drop backbone or daisy chain. Each network layout has
advantages and disadvantages, depending on the application and/or
environment. It is up to you or your system designer to decide which
layout is best for your installation.
Multi-Drop Backbone Layout
In a multi-drop backbone layout, each Xanbus-enabled device on the
network is connected by a drop cable to the network bus or backbone
using a network connector, as shown in Figure 2-5.
Table 2-1
Network Components and Part Numbers
Network Component Part Number
Network termination—Male (2 per pack) 809-0901
Network termination—Female (2 per pack) 809-0905
Three-way network connector 809-0903
Network cable 3 ft. (0.9 m) 809-0935
Network cable 5 feet (1.5 m) 809-0936
Network cable 7 feet (2.0 m) 809-0937
Network cable 10 feet (3.0 m) 809-0938
Network cable 14 feet (4.3 m) 809-0939
Network cable 25 feet (7.6 m) 809-0940
Network cable 50 feet (15.2 m) 809-0941
Network cable 75 feet (22.9 m) 809-0942
Important:
Do not mix the two types of network layouts. Mixed
configurations are not supported by Xantrex.
To Next Page
Loading...
