Configuration Using the System Control Panel
975-0298-01-01 3–5
Device Setup Menus
Device Setup menus display status information and changeable settings.
Changeable settings are identified by the square brackets [ ] around values
in the right-hand column.
To display the Setup menu for a device:
u On the Select Device menu, highlight the device name and press
Enter.
-Or-
From the Device Home screen, press Enter.
Changing Settings for a Device
You can view and change device settings from the device setup menu.
Basic menu Each Device Setup menu can be displayed in Basic and Advanced
formats. The Basic menu contains configuration items you may have to
adjust routinely, or as part of initial setup.
Advanced menu The Advanced menu gives you access to the full set of configuration
menus for that device, including everything displayed on the Basic menu.
As a safeguard against unintended advanced configuration, the System
Control Panel displays the Basic menu by default. To view the Advanced
menu, you must perform a special keypress.
Figure 3-2
Selecting a Device Setup Menu
Select Device menu
Select Device
XW6048
XW6048 00: Setup
Meters
[Enabled]
[Disabled]
[Disabled]
[Enabled]
[Disabled]
[Operating]
XW Inverter/Charger
Setup menu
To view Device Setup
menu, highlight the device
name and press Enter
Note: The System Control Panel displays
only four lines of the Setup menu at one
time. To view additional settings, press
the Down arrow button.
To Next Page
Loading...
