EN
11
27
EN
3. Loop record
Sets the length of videos that are saved in the device memory.
4. Time lapse Interval
Allows you to enable the time-lapse recording mode and adjust the interval between
subsequent shots.
5. WDR
Allows you to enable or disable Wide Dynamic Range (WDR) mode, which improves
the quality of recordings in low lighting conditions, e.g. at night.
6. Video stamps
Lets you set what information is displayed on the videos that the camera recorded.
You can choose from the following: time and date stamp, GPS watermark stamp,
your vehicle's license plate and the speed with which the car is moving.
7. Audio
Allows you to enable or disable audio recording.
8. Speaker Volume
Sets the volume at which the sound from the recording is played.
9. Key tone
Allows you to turn the sound of buttons being pressed on or o.
10. Boot-up tone
Allows you to turn the sound played by the device when it is activated on or o.
11. IR Lamp
Allows you to turn the infrared light LEDs located around the lens on or o.
LEDs provide additional illumination, using infrared light which is not visible
to the human eye, allowing you to record videos at night.
12. G-Sensor
Allows you to activate and set the sensitivity of the camera's gravity sensor. When
the sensor is turned on, the device detects a shock caused e.g. during a car cash and
will automatically record a short video that is not overwritten by the loop recording
function.
13. Parking Monitor (Parking mode)
Allows you to activate the parking mode of the camera. When this mode is on and
the device detects a shock (such as a parking crash), the device will automatically
turn on and start recording a short video that will not be overwritten by the loop
recording function.
To Next Page
Loading...
Need help?
General
