Need help?Do you have a question about the XC-Tracer Mini and is the answer not in the manual?
Press and hold the red button until beep-beep is heard; LED blinks every 2-3 seconds.
Press and hold the red button until beep-beep is heard; LED stops blinking.
Press and hold red button for beep-beep; battery status indicated by beeps, then beep-beep-beeeeeep.
Press and hold the red button until beep-beep is heard to turn off the device.
Connect via USB, press red button briefly; SD card appears as drive with TXT config file.
Setting reset=yes resets to factory defaults; requires deleting entries to apply.
Sets 12 tones for climb/sink rates, defining frequency, interval, and audibility.
Save changes by unmounting/ejecting device after editing the file and before turning on.
Connect via USB, download new firmware from website, copy to SD card, briefly press button to install.
Press and hold red button for 1 minute to disconnect battery for a hard reset.
To Next Page
General