PAGE 4
OPERATING INSTRUCTIONS FOR 7 kW XENON SYSTEM
CONNECTIONS
1. Connect lamphead cable to the (14) pin OUTPUT MS CONNECTOR located on the top of the xenon
power supply cabinet.
2. Connect the AC power cable to the (4) pin twistlock AC INPUT POWER CONNECTOR located pn the
top of the xenon power supply.
3. Connect the power cable to the power source.
4. When the power is energized the following should occur:
a. The green LED indicator lights on the top of the xenon power supply should light.
b. Cooling fans in the xenon power supply and in the P3 should start.
c. The LED displays on the DMX control boards should light.
NOTE
THERE IS A 3 - 5 SECOND DELAY AFTER THE MAIN POWER IS ENERGIZED
BEFORE THE LAMP HEAD COOLING SYSTEM IS UP TO FULL PRESSURE.
LIGHT OPERATION
Prior to operation, the xenon bulb must be installed, and DC output set to the correct level. These
procedures are to be performed by a trained technician using the proper tools, protective measures, and test
instruments. Bulb installation procedures follow in this manual, and a separate manual detailing operation of
the xenon power supply is furnished with the unit.
This unit is designed to operate from a remote DMX controller. DMX instructions and addresses are included
in a following section of this manual.
To Next Page
Loading...
Need help?
General