Xerox 8830 - Page 327

7.1 MEDIA DRIVE (2 OF 2)
A7P1 APPROXIMATE VOLTAGES: A7P1 DISCONNECTED
FROM DRIVE MOTOR PWB (A7)
CAUTION: TO PREVENT DAMAGE TO THE MOTOR
COMPONENTS. TURN OFF THE POWER SWITCH (0) BEFORE
DISCONNECTING ANY PLUG8.
PIN
P1-8
P1-7
P1-6
P1-4
STANDBY
VOLTAGE
+3.6 VDC
+3.8 VDC
0 VDC
+3.8 VDC
(0703)
VOLTAGE
+3.8 VDC
+9.8 VDC
0 VDC
+3.8 VDC
[ 0704 ]
VOLTAGE
+3.8 VDC
+3.8 VDC
0 VDC
+3.8 VDC
WITH A7P2 DISCONNECTED FROM THE DRIVE MOTOR PWB
(A7), THE APPROXIMATE RESISTANCES OF THE DRIVE
MOTOR (MOT1) ARE AS FOLLOWS:
A7P2-1 TO A7P2-2 - 3,5 OHMS.
A7P2-3 TO A7P2-4 - 3,5 OHMS.
ALL THREE DRAWER INTERLOCK SWITCHES MUST BE
ACTUATED (CLOSED) BEFORE THE MEDIA DRIVE MOTOR
WILL OPERATE.
DRIVE MOTOR
PWB (A7)
J2 J1
DRIVE MOTOR
PWB (A7)
ROLL 1
FEED CLUTCH
(BEHIND GEAR)
REWIND CLUTCH
(BEHIND GEAR)
ROLL 2
FEED CLUTCH
(BEHIND GEAR)
ROLL 2
REWIND CLUTCH
(BEHIND GEAR)
ROLL 3
FEED CLUTCH
(BEHIND GEAR)
ROLL 3
REWIND CLUTCH
(BEHIND GEAR)
LEFTSIDE
8830
1/98
7-43
Chain 7 Paper Supplying