28. (Figure 13): Route the new Scanner Harness, and Ul Power Harness.
Connect (he center connector of the Ul Power Harness
to J3
on
the MCB.
Attach the middle connector
of the Scanner Harness to J5
on the MCB.
B
Attach the end of the UI
Power Harness (P1) to
the Hard Drive.
Route the Ul Power Harness underneath the MCB (area
indicated by dotted lines). Then mount the other end of the
Ul Power Harness (J15) to the Connector Panel.
Figure 13 Overhead view of 8830 Controller showing routing of new Scanner and Ul Power Harnesses
General Procedures
Installation of Tags 7 and 6
3/98
6-34
8830 DDS
A
To Next Page
Loading...
