34. Stand the 8830 Controller on its end, so that It is positioned ready to mount back onto the
8830 Printer. Reconnect the 3 connectors that run through the 8830 Printer Right Lower
Cover Into the 8830 Controller.
• P13 on the 8830 Controller MCB
• 8830 Controller Exhaust Fan connector (P1)
J1 on the 8830 Controller PMC PWB
35. (Figure 16): Install the following EME clips on the inside of the 8830 Printer Right Lower
Cover.
NOTE: Remove the adhesive backing on the clips after positioning them, and secure
them to the cover.
Install 40-posltion clip
to P12 cable. (NOTE:
Ensure that slack Is
removed from cable
prior to Installing clip.)
Install cube-shaped
clip above harness
Figura 16 View from Inside Printer Right Lower Cover showing positioning of EME
Clips
36. (Figure 17): install the last EME gasket (from Tag 8 upgrade kit) on the inside of the 8830
Controller Cover.
Place EME gasket -
on Inside top of
8830 Controller
Cover, as shown
Figure 17 Placement of EME gasket on 8830 Controller Cover
37. Strike Tag 7 and Tag 8 on the 8830 Controller Tag Matrix. (It's located on the Inside of the
8830 Controller Chassis, facing up.)
38. Replace the 8830 Controller Cover.
39. Reconnect all cables running from the 8830 Controller to the 8830 Printer.
40. Reinstall the 8830 Controller on to the 8830 Printer.
NOTE: If the Controller ever needs to be replaced again in the future (due to electrical or
mechanical failure) replace with spare part number 101K29974 (or higher) and strike tags
7 and 8 on the new 8830 Controller Tag Matrix.
41. Install the 8830 Printer firmware upgrades, If present.
42. Install the most current 8830 Controller firmware. ,
43. Power off all components of the 8830 DDS, and power on in the following order: 7356
Scanner, 8830 Controller, 8830 Printer. Run a test print to ensure correct system opera-
tion.
44. Inspect the test print for the following:
• RAM
• HDD "present"
• 8830 Controller most current firmware level
45. Return to the 8830 DDS Installation Procedure in this manual.
General Procedures
Installation of Tags 7 and 8
3/98
6-36
8830 DDS
A
To Next Page
Loading...
