Xerox Versant 2100 Press - Page 43

While waiting for the Fuser Assembly to cool down, locate the tools you will need to
complete the removal and replacement procedures.
• Fuser Holding Rack
• T10 and T15 Torx drivers (located in the Nationalization Kit)
• Fuser Handles (originally stored inside the Paper Tray 2 compartment)
• Pressure Roll Handles (originally stored inside the Paper Tray 2 compartment)
1. Power off the press by pressing the On/Off button on the right side of the Control
Panel.
2. When the indicator light stops blinking, open the Left Front Door and the Center
Front Door and switch off the main power switch.
5-21Xerox
®
Versant™ 2100 Press
Quick Start Guide
Maintenance