Xerox Versant 2100 - Page 202

Jam Clearance SolutionJam Area
If paper is jammed in Areas 3 and / or 5, perform the following steps:
1. Before removing a die set from the punch unit, ensure
Areas 3 and 5 are clear of any jammed paper.
2. If there is not any paper found in these two areas, then
remove the die set from the punch unit; refer to Changing
Die Sets in the AdvancedPunch Pro (Removing / Installing).
3. Remove any jammed paper.
4. Reinstall the die set into the punch unit.
Xerox
®
Versant
®
2100 Press14-26
User Guide
GBC AdvancedPunch Pro