- Bypass (Tray 5): 13 x 19.2 in. / 330.2 x 488 mm
- Trays 6 and 7: 13 x 19.2 in. / 330.2 x 488 mm
Printing Resolution
• Print Engine Imaging Resolution: 2400 x 2400 dpi
• Print Server RIP Resolution (print server to print engine): 1200 x 1200 dpi
First Print: Out Time
First Print: Out Time is the minimum time from when the press receives a job from the
print server to the time when the trail edge of the first print passes through the press
exit sensor.
From standby mode, the system usually takes less than 1 minute to the start printing
• From a cold start (power on or power saver), the system takes less than 5 minutes to
start printing
Press Warmup Time
The press warmup times vary depending on the current state / mode of the press. Warmup
times are listed as follows:
• From a cold start (either power on or power saver mode), less than 5 minutes
• From Sleep Mode / Power Saver, less than 5 minutes
• From Standby Mode, less than 1 minute
• When switching print modes (such as from black only to full color), approximately 2
minutes
Paper Tray Information
Trays 1, 2 and 3
When the press is first installed, the tray size setting for Trays 1 and 3 are set at 8.5 x
11 inches or A4 (LEF). The tray size setting for Tray 2 is set at 11 x 17 inches or A3 (SEF).
When the Stock Library Manager is installed on the print server, the default for all trays
is Letter (8.5 x 11 inches). At the Stock Library Manager, the operator can then set those
trays to different stock size settings.
The specifications for each tray are:
• Maximum of 550 sheets of 24 lb. (90 gsm) uncoated paper; 28-80 lb. cover (105-120
gsm) coated stock
• Paper weight range of 18 lb. Bond to 95 lb. Cover (64 gsm to 256 gsm)
• Paper sizes starting at 5.51 x 7.17 in. / 140 x 182 mm to a maximum of 13 x 19.2 in.
/ 330.2 x 488 mm
Xerox
®
Versant
®
2100 Press3-2
User Guide
Technical Specifications
To Next Page
Loading...
