Cleaning the Exterior
1. Wipe the exterior with a soft cloth moistened with water. If dirt is difficult to remove,
try gently wiping with a soft cloth moistened with a small amount of neutral detergent.
2. Wipe off any excess water from the exterior with a soft cloth.
Clean Fuser Assembly
If you see dry ink / toner debris on the back side of the print output, select and run the
Clean Fuser Assembly routine from the press Control Panel to clean the fuser component
and address this image quality issue caused by contaminants in the fuser.
Note
If you still notice contaminants on the back of the prints after running this procedure,
contact Service. Dry ink/toner debris may be coming from the Transfer roll area instead
of the fuser.
1. Select the Tools button on the Control Panel.
2. Select the Clean Fuser Assembly icon.
3. From the screen that displays, you will specify the paper tray to use and the number
of blank sheets to print for the “Clean with Paper” method of removing the unfused
dry ink / toner.
4. From Paper Supply, select the paper tray to use.
Note
Any type of paper and size can be used. However, the smooth surface of coated paper
does offer more contact area to the pressure roll.
5. From Number of Sheets, select the number of blank sheets to print (1 to 5).
Note
For best results, run a minimum of 5 sheets.
6. Select Save.
7. Press the Start button. The system begins the cleaning process and displays a
“successfully completed” message when finished. Select OK.
Note
The process with 5 sheets of paper will take approximately one minute.
Xerox
®
Versant
®
2100 Press9-2
User Guide
Maintenance
To Next Page
Loading...
