June 2014
6-21
Xerox® WorkCentre® 3025 Multifunction Printer Service Manual
Diagnostic Information, Entering Diagnostic Mode
General Procedures and Information
Diagnostic Information
This section of the Service Documentation contains information about Diagnostic Procedures.
This section also contains various other product-specific information that may be useful and/or
needed for product servicing.
Entering Diagnostic Mode (Tech Mode)
To enter Diagnostic (Tech) Mode, use the steps listed below.
For Model 3025 NI:
1. From the Control Panel, press the <Menu> button.
2. Press the <#> button
3. On the keypad, enter 1934
4. Press <OK>
For Model 3025 BI:
1. From the Control Panel, press the following buttons in quick succession: <Menu > Back >
Up Arrow > Down Arrow > OK >Stop
2. Press the <Menu> button
3. Select [Diagnostics]
In Diagnostic Mode, use the navigation buttons to scroll to the following sub-menus.
Press<OK> after selecting menu items.
• Data Setup
• Machine Test
• Report
• Exit Diagnostics
To Next Page
Loading...
