June 2014
6-23
Xerox® WorkCentre® 3025 Multifunction Printer Service Manual
Entering Diagnostic Mode
General Procedures and Information
Table 2 Diagnostic Mode Menu - Machine Test
Level 1 Level 2 Level 3 Level 4 Level 5 Level 6
Machine Test DC305 UI Test Press any key to start NOTE: Refer to GP 9 for test
procedure
*Modem Test Fsk ? Press <Stop> button to cancel
DRAM Test DRAM Test OK
ROM Test Press <OK>
*Continuous DTMF DTMF # Line1
DTMF *Line1
Shading Test Shading & Print Print? Yes/No
Scan Aging (Internal Eng. test) P.1...P.2, etc. Press <Stop> button to cancel
EDC Mode DC330 Component Control 100 Motor Feed Motor Status:
Off/On
Feed Motor Slow Status:
Off/On
101 Clutch Tray 1 Pickup Status:
Off/On
102 Sensor Feed Sens Status:
Low
Width Sens Status:
Low
105 Charger K MHV Bias Status:
Off/On
106 Development K Dev Bias Status:
Off/On
K Dev AC Status:
Off/On
107 Transfer K THV Bias Status:
Off/On
K THV - Bias Status:
Off/On
109 Fuser Temp A Status:
[0]
110 LSU LSU Mot1 Run Status:
Off/On
LD Power4 Status:
Off/On
LSU HSync4 Status:
Low
To Next Page
Loading...
