June 2014
6-26
Xerox® WorkCentre® 3025 Multifunction Printer Service Manual
Report, EDC (Diagnostic) Mode
General Procedures and Information
Report
The following printed reports can be generated by the machine:
• Protocol
The Protocol report is used to check for send and receive errors. It shows the sequence
of the CCITT group 3 T.30 protocol during the most recent sending or receiving operation.
• Supplies Info
The Supplies Information report shows Toner Cartridge information such as toner remain-
ing, toner capacity, and toner product date.
• Configuration
The Configuration report shows the status of user-selectable options, and should be
printed to confirm changes made to machine settings.
• Error Info
The Error Info report shows a list of all machine errors since the last service call.
• Usage Page
The Usage Page report shows the number of duplex and simplex prints since the last ser-
vice call.
• Component Check
The Component Check report shows the results of component testing while in Diagnostic
Mode.
EDC (Diagnostic) Mode
The following diagnostic routines can be accessed in EDC Mode:
• NVM Initialize
The NVM Initialize routine provides the capability to initialize (set to default) machine con-
trol parameters stored in Non-Volatile Memory (NVM). Refer to Table 1.
• NVM Read/Write
The NVM Read/Write routine provides the capability to review and modify machine con-
trol parameters stored in Non-Volatile Memory (NVM). Refer to Table 1.
• DC330 Test Routines
This routine provides the capability to verify component functionality by monitoring input
signals and controlling output states. Refer to Table 2.
Table 1 NVM Codes and values
NVM Code LCD Definition Default Min Max
105 MHV Bias Charger HV Black DC Duty 210 50 250
106 Deve Bias Deve DC Black 190 50 250
107 ATTR Bias Transfer2 HV 130 50 250
109 Fuser Heat Standby target temperature 10 0 15
110 LSU LSU Power at Normal Speed 450 50 600
Table 2 Input/Output Components
Diagnostic
Code Displayed name Definition
Input/
Output
State
Displayed
100-Motor Feed Motor Feed Motor is On/Off Output On [Off]
Feed Motor Slow Detect if Feed Motor
runs at normal speed
Input High [Low]
101-Clutch Tray1 Pick-Up Engages drive to pick
up a paper from tray1
Output On [Off]
102 Sensor Feed Sens Detects when a paper
is at Feed sensor.
Input High [Low]
Width Sensor
105 Charger K MHV Bias Black MHV bias volt-
age on at normal drive
level
Output On [Off]
106 Develop-
ment
K Dev Bias Black Dev bias voltage
on at normal drive level
Output On [Off]
107 Transfer K THV Bias Black THV bias voltage
on at normal drive level
Input On [Off]
K THV(-) Bias Black THV bias voltage
on at normal drive level
Input On [Off]
109 Fuser Fuser Temp A Detects what the tem-
perature A is on fuser.
Input Numeric 3
digits
To Next Page
Loading...
