June 2014
4-30
Xerox® WorkCentre® 3025 Multifunction Printer Service Manual
REP 1.16, REP 1.17
Repairs
Figure 2 Paper Tray Removal (Front View)
Replacement
NOTE: Tapered Plastic Screws and Round Machine Screws are used to hold the PWB to the
frame. Make sure that the Plastic Screws go into plastic components and Machine Screws go
into the metal frame.
Install the components in the reverse of removal.
NOTE: Make sure the Locating Pins and Tabs on the Paper Tray align with the cutouts in the
frame.
REP 1.17 Transfer Roll
Parts List on PL 5.1
Removal
1. Switch Off the Printer and unplug the Power Cord.
2. Remove the Toner Cartridge.
3. Remove the Middle Cover (REP 1.4).
4. Remove the Fuser Module (REP 1.17).
5. From the rear of the printer, using a small screwdriver release the latches (2) and push
the Transfer Roll Bushing into the printer (Figure 1).
Figure 1 Transfer Roll Bushing Latches (Rear View)
Left Frame
Right Frame
Latches
To Next Page
Loading...
