Xerox WorkCentre PE16 - Copying

5-14
Disassembly and Reassembly
Service Manual
July 2003 WorkCentre PE16
5.11 SMPS
1. Before you remove the SMPS, you should remove:
- Engine Shield Ass’y(see page 5-12)
2. Remove the three screws securing the Inlet Bracket
and remove it
3. Unplug the one connector and remove the one screw
securing the Engine Shield.
4. Remove the three screws securing the SMPS. Then
lift the SMPS out, as shown below.
Inlet Bracket
SMPS