WorkCentre Pro 423/428 2-202 CHAPTER 2 TROUBLESHOOTING
03/02 How to use the Diagnostic C/E Mode
Chain Function Item Description Default Description Access by
58 311 Selecting Auto Deletion for Documents
received in the Mail Box
0: To be deleted after comm.1: To
be stored after comm.
01 User
58 350 Outputting Protocol Monitor 0:Manual output 1:When comm..
error occurs 2:Output all
00 Main unit is loaded with the Protocol Monitor feature which is capable of
visually checking the status and cause of communication failure when it
occurs so that quick action is taken. This data specifies a timing to
output the Protocol Monitor. For G4 comm., each data in Chain=057 and
Function=830 to 832 is effective.
CE
58 352 Controlling protocol monitor report
ejection under specific conditions
Bit0:RTN/PIN send/receive
bit1:RTP send/receive bit2:PPR
send/receive bit3:CTC send/
receive bit4:EOR send/receive
bit5:FTT send/receive(equal
conditions for fast mode) bit6:
command FCS error
bit7:command resend
bit8:Momentary failure bit9:decode
error (G3 only) bit10: Collection of
auxiliary information bit:11
Reserved bit12: Reserved bit13:
Reserved bit14: Reserved
bit15:Custom use
0000
58 353 Outputting Power Off Report (for debug) 0:Off 1:On 01 This report will be output to inform the operator of deletion of documents
stored due to the power shutdown or similar accidents. This data
determines how the Power Off Report can be output. Do not change the
data unless otherwise instructed.
CE
58 354 Outputting Multi-Poll Report 0:Off 1:On 01 While Outputting Broadcast/Multi-Poll Report in Chain=058 and
Funotion=302 specifies an outputting timing foa a broadcast job, this
data specifies how to output a multi-poll job.
CE
58 355 Activity Report Log Display Priority 0:Addressed name>Remote
terminal name>Tel. No.>Remote
ID>CCITT
1:Remote ID>Tel.No.>Remote
terminal name>Addressed
name>CCITT
00 Determines the priority of data to be printed for the remote terminal
name of Activity Report. When “0” is selected as setup on delivery,
Addressed name recorded in the Speed dial list->Local name recorded
in the remote terminal ->Tel. No. ->ID code data for the CSI/CIG/TSI
signal->Communication mode will be printed on sending. Local name
recorded in the remote terminal->ID code data for the CSI/CIG/TSI
signal->Communication mode will be printed on receiving.
CE
58 356 Handling of Transmission Report 0:To be retained 1:Auto deleted in
24 hours
01 Mainly to control handling of the document not transmitted when “On” is
selected as described in Chain=058 and Function=559(Selecting resend
for the documents not transmitted). When the documents not sent are
retained, Send Fault documents will be accumulated in memory and
eventually overflows memory.
CE
58 360 Registering power failure/reboot (including
emergency) into Activity Report
0:Off 1:On 00
To Next Page
Loading...
