WorkCentre Pro 423/428 03/02 CHAPTER 6 GENERAL
6-10 6.1 Specifications
6.1.7 System feature – Memory
1. Memory for Fax
This machine has a standard memory of 2MB embedded. Additional 8MB memory and
1GB HDD (10MB memory is necessary) are optionally available. These are used to
accumulate image information at transmission and reception.
2M memory (standard)
Corresponding number of sheets storable for
Send/receive operations (Using PLATEN and SEF)
Memory capacity
Standard Fine res. Super fine
(400dpi)
Super fine
(600dpi)
2Mbyte (MMR) 101 66 37 23
2Mbyte (JBIG) 129 84 45 29
8M memory (FXAP Standard)
Send/receive operations (Using PLATEN and SEF)Memory capacity
Standard Fine res. Super fine
(400dpi)
Super fine
(600dpi)
10Mbyte (MMR) 590 369 210 131
10Mbyte (JBIG) 756 473 259 165
1GB HHD(OPTION)
Memory capacity Send/receive operations
(MMR) 960 documents max/960 pages max
Or until memory becomes full
(JBIG) Same as above
Ref. On Send/receive operations
ITU-T No.1 Chart is used as the document. The figure indicates the number of
sheets storable before being switched to Immediate Send/Receive operation.
(Actually, over the indicated number can be sent/received by the Immediate
Send/Receive operations.) (threshold: 20%)
2. Memory for Copy
With the optional electronic sort kit (1GB HDD) added
Number of sheets sortable: 100 (A4)
6.1.8 Electrical feature
1. Operational power supply
Single phase 2 wire line
Input voltage Current capacity Frequency
100VAC10% 15A 50/60Hz±2%
110VAC±10%(TFX) 13A 60Hz±2%
220-240VAC±10%(FXA) 7A 50/60Hz±2%
2. Power cord
To be plugged into the main processor and prepared by each Opco (exceptTFX).
3. Leakage breaker
• Leakage breaking current: 10A or below
• Leakage breaking response time: within 100msec
4. Billing Counter
• Electronic billing counter is embedded.
• Individual counter is equipped in each mode.
1) Copy counter
2) Fax counter
3) Printer counter
5. Count up is made as follows:
• Simplex copy:
1) Outputting onto the Face Down Tray
When the trail edge passes through the Fuser Exit Sensor
2) Outputting onto the Face Up Tray
When the trail edge passes through the Fuser Exit Sensor
3) Outputting onto the Finisher
When the trail edge passes through the Fuser Exit Sensor
• Duplex copy:
When the first side trail edge passes through the Fuser Exit Sensor
The second side is in the same way as Simplex copy.
• Number of Count up
Simplex copy: 1
Duplex copy: the first side and second side, each 1
Test Print (Simplex): 1
Transparency interleaf: 0 for blank
To Next Page
Loading...
