10 - 44
W
USB PD
The power delivered by the charger shall be between min [10] Was required by the
radio equipment, and max [44] Was in order to achieve the maximum charging
speed. USB PD fast Charging.
EU Regulations
RED Declaration of Conformity
Xiaomi Communications Co., Ltd. hereby declares that this Tablet with Bluetooth and Wi-Fi 2410CRP4CG
is in compliance with the essential requirements and other relevant provisions of the RE Directive
2014/53/EU. The full text of the EU declaration of conformity is available at the following internet
address: www.mi.com/en/certi
fication
RF Exposure Information (SAR)
This device is in compliance with Specific Absorption Rate (SAR) limits for general population/
uncontrolled exposure (Localized 10-gram SAR for trunk, limit: 2.0W/kg) specified in Council
Recommendation 1999/519/EC, ICNIRP Guidelines, and RED (Directive 2014/53/EU).
During SAR testing, this device was set to transmit at its highest certified power level in all tested
frequency bands.
When aaching the device near the body, a belt clip or holster should be used which does not
contain metallic components. RF exposure compliance was not tested or certified with any
accessory containing metal worn on the body, and use of such an accessory should be avoided.
Certification Information (Highest SAR)
SAR 10 g limit: 2.0 W/Kg,
SAR Value: Body: 0.993 W/Kg (0 mm distance).
Legal Information
This device may be operated in all member states of the EU and UK.
Observe national and local regulations where the device is used.
This device is restricted to indoor use only when operating in the 5250 to 5350 MHz,
5945 to 6425MHz frequency range in : AT,BE,BG,HR,CY,CZ,DK,EE,FI,FR,DE,EL,HU,
IE,IT,LV,LT,LU,MT,NL,PL,PT,RO,SK,SI,ES,SE,UK(NI),IS,LI,NO,CH,TR
Wi-Fi connectivity (including Wi-Fi frequency bands, Wi-Fi standards and other features as ratified
in IEEE Standard 802.11 specifications) may vary based on regional availability and local network
support. The function may be added via OTA when and where applicable
Restrictions in the 2.4 GHz band:
Norway: This subsection does not apply for the geographical area within a radius of 20 km from
the centre of Ny-Ålesund.
Please ensure the used power adapters are compliant with applicable country regulations and
international and regional safety standards.
Frequency Bands and Power
This tablet offers the following frequency bands in EU areas only and maximum radio-frequency power:
Bluetooth: 20 dBm
Wi-Fi 2.4 GHz band: 20 dBm
Wi-Fi 5 GHz: 5150 to 5250MHz: 23 dBm, 5250 to 5350 MHz: 23 dBm,
5470 to 5725 MHz: 23 dBm, 5725 to 5850 MHz: 14 dBm, 5945 to 6425 MHz: 23dBm
Wireless reverse charging: 110~148 KHz < 37.7 dBuA/m at 10m Distance
FCC Regulations
This tablet complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This tablet has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Information (SAR)
This device meets the government’s requirements for exposure to radio waves. This device is
designed and manufactured not to exceed the emission limits for exposure to radio frequency
(RF) energy. The exposure standard for wireless devices employs a unit of measurement known as
Specific Absorption Rate, or SAR.
The SAR limit set by the FCC is 1.6 W/Kg. For body-worn operation, this device has been tested
and meets the FCC RF exposure guidelines for use with an accessory that contains no metal.
RF exposure compliance with any body-worn accessory that contains metal was not tested and
certified, and use of such body-worn accessory should be avoided.
FCC Note
Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
Shielded cables must be used with this unit to ensure compliance with the Class B FCC limits.
Operation of transmiers in the 5.925-7.125 GHz band is prohibited for control of or
communications with unmanned aircra systems.
03
To Next Page
Loading...
