• Do not allow the robot vacuum to pick up hard or sharp objects such as building materials, glass, or
nails.
• Do not use the mopping mode on carpets. Set virtual walls or restricted areas to exclude carpeted
areas for mopping tasks.
• Turn off and unplug the power supply before cleaning and maintaining the robot vacuum and
mop-cleaning station.
• Do not place the robot vacuum upside down. Laser radar housing should never touch the ground.
• Do not pick up the robot vacuum by its laser radar cover.
• Only use this product as directed in the user manual. Users are responsible for any loss or damage
arising from improper use of this product.
• Make sure the robot vacuum is turned off when being transported and kept in its original packaging if
possible.
• Do not wipe with a wet cloth or rinse the robot vacuum and mop-cleaning station with any liquid. Aer
cleaning washable parts, dry them sufficiently before installing them for use.
• When the mop-cleaning station is cleaning the mop pads, do not drag the robot vacuum out of the
mop-cleaning station to avoid causing any damage.
• The appliance is to be supplied through a residual current device (RCD) having a rated residual
operating current not exceeding 30 mA.
• This appliance is considered to be suitable for use in countries having a tropical climate. It may also be
used in other countries.
• No action needed from users to shi the mop-cleaning station between 50 Hz and 60 Hz, and the
product can adapt itself for both 50 Hz and 60 Hz.
• The laser sensor in this product meets the lEC 60825-1: 2014 Standard for Class 1 laser products.
Please avoid direct eye contact with it during use.
2
To Next Page
Loading...
