Xiaomi X20 - Page 5

Steps to remove the baeries
The information is applicable only for disposing of this product and is not part of the regular operating
instructions.
1. Keep the robot vacuum away from the mop-cleaning station and make it operate until its baery level
is too low to continue cleaning.
2. Turn off the robot vacuum.
3. Remove the boom shell of the robot vacuum.
4. Press down on the clips and pull out the baeries' connectors to take out the baeries.
CAUTIONS:
• Make sure the baery is flat and the robot vacuum is far away from the mop-cleaning station before
removing the baery.
• Remove the entire baery pack together, and make sure not to damage the outer casing of the baery
pack to prevent short-circuiting or leakage of harmful substances.
• If you come into physical contact with any substance that may leak out of the baeries, rinse the
contact area with plenty of water and seek medical aention immediately.
• The baery must be removed from the appliance before it is scrapped.
• The appliance must be disconnected from the supply mains when removing the baery.
• The baery is to be disposed of safely.
for indoor use only
4