29
Power-on display call sign setting
The G90 can be set to show your call sign or other text on the display when powering up.
Setting：
1. Press and hold the [VM] button to enter the text editor;
2. At the bottom of the display is the character selection area. Rotate the main control knob to select the desired character. Press the
main control knob to select the character;
3. Press the [NB] button to delete the last character; press the [VM] button to exit the editor; press the [PRE] button to save and exit
the editor;
4. When the G90 is powered up, the text information you saved will appear on the display.
Text editor function buttons:
SAVE: [PRE] button
BACK: [NB] button
QUIT: [VM] button
To Next Page
Loading...
