XIEGU G90 - Page 6

XIEGU G90 CHEAT SHEET 6
FUNC Button
and then “PRE”/
“ATT” Button
Does nothing
FUNC Button
and then “CMP”/
“F-L”
Set Lower Limit of the
Filter Bandwidth
 Turn the Tuning control to set the desired filter limit.
 Press the “CMP/”F-L” again to save the value
FUNC Button
and then “NB”/
“F-H”
Set Upper Limit of the
Filter Bandwidth
 Turn the Tuning control to set the desired filter limit.
 Press the “NB/”F-H” again to save the value
FUNC Button
and then “AGC”/
“SPL”
Split Frequency
Operation
See the current G90 user manual for a good description of how to use this feature. You will see an
icon on the left side of the display between the VFO A and VFO B when this split operation is in use.
VFO A is the receive frequency and VFO B is the transmit frequency.
FUNC Button
and then press
the Volume
Control
VOX Configuration
After pressing this button sequence, the VOX options appear on the display.. The options are:
 ‘VOX’ .. Rotate the Tuning control to select VOX on or off. If on, then a VOX icon appears on the
display. Press the Volume control. Or just press the Tuning control to end this VOX set up if you
are only turning VOX off or on.
 ‘VOX Gain’ .. Rotate the Volume Control to set the VOX Gain to from 0 to 100. Press Volume
 ‘ANTI-VOX’ .. Rotate the Volume to set the Anti VOX Gain to from 0 to 100. Press Volume
 ‘VOX DLY’ .. Rotate the Volume Control to set the VOX Delay to from 0 to 2 seconds in .1
second increments. Press the Volume control to end the VOX configuration.
 VOX is also usable with using AF In via the ACC port.