20
Function and definition of displayed icons:
: pre-amplifier is ON. The icon character A indicates that the attenuator is in-
line. No character indicates Normal mode.
: noise blanker is ON
: automatic antenna tuner is in circuit.
: voice compression CMP is active
: squelch is ON
: voice triggered TX control function is ON
: AGC control is set to Slow (alternatively AGC-F, AGC-AUTO, AGC
settings may be indicated)
: supply voltage display.
: Current operating mode in use – USB, LSB, CW, CW-R, AM or FM.
: As the split mode symbol is indicated between VFO-A and VFO-B, VFO-
A is the current receive frequency and VFO-B is the transmitting frequency.
Without the “Split” indicator the text VFO-A and VFO-B indicate the frequencies
of the two VFOs.
: SPL split frequency receiving & transmitting mode is active.
: Loudspeaker mode. A short press-in of the volume knob switches between
earphone and speaker modes.
: All buttons locked symbol – settings cannot be changed until the buttons
are unlocked again.
: While receiving, the received signal strength
is indicated by the green/red line and can be read off against the top row of
figures. When in transmit mode, the same indicator can be read against the
bottom line indicating the power being transmitted.
R±XXX – displayed under Rx DbM level in the waterfall is the current RIT value.
: During transmission the SWR meter displays the standing-
wave ratio value of your antenna system.
: This chart Indicates the settings of the DSP receiver filter
To Next Page
Loading...
