6 / 12
3.2 Menu Functions:
【PRE】Switch receive preamp on or off.
【ATT】Switch receive signal attenuator on or off.
【MODE】Select desired operating mode – CW/AM/LSB/USB.
【AGC】 Select AGC level – FAST/SLOW/OFF.
【NB】 Select NB level between 1 and 4.
------------------------------------------------------------------------------------------------------------------------------------------------
【A/B】 Switch between VFO A & VFO B.
【A=B】 Set VFO A the same as VFO B.
【SPLT】 Select SPLIT operating mode.
【RIT】Select RIT mode – adjust via selector knob B,
setting shown on RIT display in LCD.
【POW】 Set RF output power – adjust via selector knob B,
level displayed via red line in LCD.
------------------------------------------------------------------------------------------------------------------------------------------------
【V/M】Select VFO or Memory mode. Select
channel/frequency using selector knob B.
【M>V】In memory mode, move current
frequency to VFO and switch to VFO mode.
【MW】In VFO mode, store current frequency
and settings in memory.
【MC】In memory mode, clear selected
memory channel.
【BW】Select Bandwidth – 0.5/2.2/15 kHz.
------------------------------------------------------------------------------------------------------------------------------------------------
【KEY】Select keyer – Manual/Auto L/Auto R.
【KSPD】Select keying speed - adjust via selector
knob B, speed displayed under KEY in LCD.
【TIME】Set Internal Clock – adjust via selector
knob B, select hour/minute with Up/Down buttons.
【SQL】Select to adjust Squelch level via selector
knob B, level shown on line display in LCD.
【VCMP】voice compression settings
To Next Page
Loading...
