Xinje VH6 Series - Page 149

143
Parameter
Name
Range
PB-30
Simple PLC segment 6 acc/dec time
0~3
PB-31
Simple PLC segment 7 operation time
0.0~6500.0s(h)
PB-32
Simple PLC segment 7 acc/dec time
0~3
PB-33
Simple PLC segment 8 operation time
0.0~6500.0s(h)
PB-34
Simple PLC segment 8 acc/dec time
0~3
PB-35
Simple PLC segment 9 operation time
0.0~6500.0s(h)
PB-36
Simple PLC segment 9 acc/dec time
0~3
PB-37
Simple PLC segment 10 operation time
0.0~6500.0s(h)
PB-38
Simple PLC segment 10 acc/dec time
0~3
PB-39
Simple PLC segment 11 operation time
0.0~6500.0s(h)
PB-40
Simple PLC segment 11 acc/dec time
0~3
PB-41
Simple PLC segment 12 operation time
0.0~6500.0s(h)
PB-42
Simple PLC segment 12 acc/dec time
0~3
PB-43
Simple PLC segment 13 operation time
0.0~6500.0s(h)
PB-44
Simple PLC segment 13 acc/dec time
0~3
PB-45
Simple PLC segment 14 operation time
0.0~6500.0s(h)
PB-46
Simple PLC segment 14 acc/dec time
0~3
PB-47
Simple PLC segment 15 operation time
0.0~6500.0s(h)
PB-48
Simple PLC segment 15 acc/dec time
0~3
Parameter
Name
Range
PB-49
Simple PLC operation mode
0: Stop at the end of single operation
1: Keep the final value at the end of single
operation
2: Cycle all the time
Simple PLC function has two functions: as a frequency source or as a voltage source of VF separation.
When simple PLC is used as frequency source, the positive and negative values of PB-00 ~ PB-15 determine
the operation direction. If the value is negative, it means that the inverter runs in the opposite direction.
As a frequency source, PLC has three operation modes, but as a VF voltage source, it has no such mode. Among
them:
0: Stop at the end of single operation
The inverter stops automatically after completing a single cycle and needs to give the operation command again
to start.
1: Keep the final value at the end of single operation
After completing a single cycle, the frequency and direction of the last section will be maintained automatically.
2: Cycle all the time
After the inverter completes one cycle, it will start the next cycle automatically until there is a stop command.
The figure below is the schematic diagram of simple PLC as frequency source. When simple PLC is used as
frequency source, the positive and negative values of PB-00 ~ PB-15 determine the operation direction. If the
value is negative, it means that the inverter runs in the opposite direction.