Xinje VH6 Series - Page 154

148
When PC-26 = 1, the timing function is turned on, the current running time U0-31 is greater than the value set
by PC-28, the inverter stops running, and Y outputs ON signal by assigning function code 26 to Y terminal.
The value of current time U0-31 is greater than the value set by PC-29. By assigning function code 41 to Y
terminal, Y outputs ON signal, but the inverter will not stop running.
When the accumulated operation time of P8-10 is greater than the set operation arrival time of PC-32, the
frequency converter will stop operation. By assigning function code 29 to the Y terminal, the Y terminal will
output ON signal.
When the cumulative power on time of P8-11 is greater than the power on arrival time set by PC-30, the
inverter will stop running. By assigning function code 25 to the Y terminal, the Y terminal will output ON
signal.
Parameter
Name
Range
PC-34
Current reached detection value 1
0.0%~300.0% (motor rated current)
PC-35
Current reached detection 1 range
0.0%~300.0% (motor rated current)
PC-36
Current reached detection value 2
0.0%~300.0% (motor rated current)
PC-37
Current reached detection 2 range
0.0%~300.0% (motor rated current)
When the output current of the frequency converter is within the set positive and negative detection width of
current arrival, the multi-function Y outputs ON signal.
VH6 provides two groups of arrival current and detection width parameters. The following figure is the function
diagram.
Parameter
Name
Range
PC-26
Timing function selection
0: Invalid
1: Valid
PC-28
Setting operation time
0.0Min~6500.0Min
PC-29
Present operation reached time
0.0Min~6500.0Min
Parameter
Name
Range
PC-30
Setting power on reached time
0~6500.0h
PC-32
Setting operation reached time
0~6500.0h