213
(1) Power supply mode of encoder
Common encoders have 5V ,12V and 24V power supply modes.
①If the encoder is powered by DC5V power supply, users can directly use PG card power supply or external
power supply.
Wiring:
Collector (single ended) type: the power supply of the encoder should be connected to Pin 7 of CN1, and
GND/0V of the encoder should be connected to Pin 6 of CN1.
For hardware version V1.0 , short circuit Pin7 and Pin8 of CN1.
For hardware version V1.1 , select the dial switch as 5V gear.
Differential type: the power supply of the encoder should be connected to Pin 7 of CN1, and the GND/0V
should be connected to Pin 6 of CN1.
To Next Page
Loading...