215
Differential type: the power supply of the encoder should be connected to Pin 7 of CN1, and the GND/0V
should be connected to Pin 6 of CN1.
③ If the encoder is powered by DC24V power supply, users need to use external DC 24V power supply to
power the encoder, or use the 24V power supply on the card A of the inverter body.
Wiring:
Collector (single ended) type 24V or Differential type 24V :
For hardware version V1.0, the power supply of the encoder and Pin 8 of CN1 should be connected to +24V of
external power supply, and GND/0V of the encoder and Pin 6 of CN1 should be connected to -24V of external
power supply.
To Next Page
Loading...