Xinje VH6 Series - Page 71

65
Group P7: Fault parameters
Parameter
Name
Setting range
Default
value
Modify
Modbus
address
(latest) fault(supported by 3720 and
above versions)
P7-13
Second time fault frequency
-
-
-
-
P7-14
Second time fault current
-
-
-
-
P7-15
Second time fault bus voltage
-
-
-
-
P7-16
Second time fault input terminal status
-
-
-
-
P7-17
Second time fault output terminal
status
-
-
-
-
P7-18
Second time fault VFD status
-
-
-
-
P7-19
Second time fault power on time
Unit:minute
-
-
-
P7-20
Second time fault operation time
Unit:minute
-
-
-
P7-21
Location information of the second
fault(supported by 3720 and above
versions)
-
P7-23
First time fault frequency
-
-
-
-
P7-24
First time fault current
-
-
-
-
P7-25
First time fault bus voltage
-
-
-
-
P7-26
First time fault input terminal status
-
-
-
-
P7-27
First time fault output terminal status
-
-
-
-
P7-28
First time fault VFD status
-
-
-
-
P7-29
First time fault power on time
Unit:minute
-
-
-
P7-30
First time fault operation time
Unit:minute
-
-
-
P7-31
Location information of the first
fault(supported by 3720 and above
versions)
-
-
P7-33
Motor overload protection mode
selection
0: Forbidden
1: Allow
1
○
0721H
P7-34
Motor overload protection gain
0.20~10.00
1.00
○
0722H
P7-35
Motor overload warning coefficient
50%~100%
80%
○
0723H
P7-39
Input phase lacking/contactor closing
protection selection
Ones bit: input phase lacking
protection
Tens bit: Contactor closing
protection selection
0: Forbidden
1: Allow
11
○
0727H
P7-40
Output phase lacking protection
selection
0: Forbidden
1: Allow
1
○
0728H
P7-41
Power on short circuit protection
towards the ground function
0: Invalid
1: Valid
1
○
0729H
P7-42
Action selection of fault relay during
automatic fault reset
0: No action
1: Action
0
○
072AH
P7-43
Interval time of automatic fault reset
0.1s~60.0s
1.0s
○
072BH